sdc_hci_cmd_le_set_conn_cte_transmit_params()

uint8_t sdc_hci_cmd_le_set_conn_cte_transmit_params	(	const sdc_hci_cmd_le_set_conn_cte_transmit_params_t *	p_params,
		sdc_hci_cmd_le_set_conn_cte_transmit_params_return_t *	p_return )

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE Set Connection CTE Transmit Parameters.

The description below is extracted from Core_v6.0, Vol 4, Part E, Section 7.8.84

The HCI_LE_Set_Connection_CTE_Transmit_Parameters command is used to set the antenna switching pattern and permitted Constant Tone Extension types used for transmitting Constant Tone Extensions requested by the peer device on the connection identified by the Connection_Handle parameter.

If the Host issues this command when Constant Tone Extension responses have been enabled on the connection, the Controller shall return the error code Command Disallowed (0x0C).

If the CTE_Types parameter has a bit set for a type of Constant Tone Extension that the Controller does not support, the Controller shall return the error code Unsupported Feature or Parameter Value (0x11).

The Switching_Pattern_Length and Antenna_IDs[i] parameters are only used when transmitting an AoD Constant Tone Extension and shall be ignored when CTE_Types does not have a bit set for an AoD Constant Tone Extension; they do not affect the transmission of an AoA Constant Tone Extension.

If Switching_Pattern_Length is greater than the maximum length of switching pattern supported by the Controller, the Controller shall return the error code Unsupported Feature or Parameter Value (0x11).

If the Controller determines that any of the Antenna_IDs[i] values do not identify an antenna in the device's antenna array, it shall return the error code Unsupported Feature or Parameter Value (0x11).

Note: Some Controllers may be unable to determine which values do or do not identify an antenna.

Event(s) generated (unless masked away): When the HCI_LE_Set_Connection_CTE_Transmit_Parameters command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[in]	p_params	Input parameters.
[out]	p_return	Extra return parameters.

Return values

0	if success.

Returns

Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.