sdc_hci_cmd_le_clear_resolving_list()

uint8_t sdc_hci_cmd_le_clear_resolving_list

(

void

)

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE Clear Resolving List.

The description below is extracted from Core_v6.0, Vol 4, Part E, Section 7.8.40

The HCI_LE_Clear_Resolving_List command is used to remove all devices from the resolving list used to resolve Resolvable Private Addresses in the Controller.

This command shall not be used when address resolution is enabled in the Controller and:

• Advertising (other than periodic advertising) is enabled, • Scanning is enabled, or • an HCI_LE_Create_Connection, HCI_LE_Extended_Create_Connection, or HCI_LE_Periodic_Advertising_Create_Sync command is pending.

This command may be used at any time when address resolution is disabled in the Controller.

Event(s) generated (unless masked away): When the HCI_LE_Clear_Resolving_List command has completed, an HCI_Command_Complete event shall be generated.

Return values

0	if success.

Returns

Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.