sdc_hci_cmd_le_iso_test_end()

uint8_t sdc_hci_cmd_le_iso_test_end	(	const sdc_hci_cmd_le_iso_test_end_t *	p_params,
		sdc_hci_cmd_le_iso_test_end_return_t *	p_return )

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE ISO Test End.

The description below is extracted from Core_v6.0, Vol 4, Part E, Section 7.8.114

The HCI_LE_ISO_Test_End command should only be used in the ISO Test mode and only for testing purposes.

The command is used to terminate the ISO Transmit and/or Receive Test mode for a CIS or BIS specified by the Connection_Handle parameter but does not terminate the CIS or BIS.

When the Host terminates the ISO Test mode for a CIS or BIS that is set to ISO Transmit Test mode only, the test counters in the return parameters shall be set to zero.

When the Host terminates the ISO Test mode for a CIS or BIS that is set to the ISO Receive Test mode, the return parameters contain the values of the test counters as defined in [Vol 6] Part B, Section 7.

If the Host issues this command with a Connection_Handle that is not for an established CIS or a BIS, the Controller shall return the error code Unknown Connection Identifier (0x02).

If the Host issues this command for a CIS or BIS that is not configured in the ISO Transmit or Receive Test mode, the Controller shall return the error code Unsupported Feature or Parameter Value (0x11).

Event(s) generated (unless masked away): When the HCI_LE_ISO_Test_End command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[in]	p_params	Input parameters.
[out]	p_return	Extra return parameters.

Return values

0	if success.

Returns

Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.