sdc_hci_cmd_vs_zephyr_read_static_addresses()

uint8_t sdc_hci_cmd_vs_zephyr_read_static_addresses

(

sdc_hci_cmd_vs_zephyr_read_static_addresses_return_t *

p_return

)

#include <softdevice_controller/include/sdc_hci_vs.h>

Zephyr Read Static Addresses.

This commands reads the controller specific static addresses.

This command shall return the static addresses programmed by the vendor at manufacturing time.

Each returned static address shall confirm to the Static Device Address definition. The two most significant bits of the address shall be equal to 1. At least one bit of the random part of the address shall be 0. At least one bit of the random part of the address shall be 1.

The Identity_Root parameter may be all zeros to indicate no identity root key being available for a given static address. The identity root key returned from Read_Key_Hierarchy_Roots command shall not be returned from this command.

Note: If no public address is provided and a static address is available, then it is recommended to return an identity root key (if available) from this command. In case a public address is provided, then it is recommended to use the Read_Key_Hierarchy_Roots command to return the identity root key (if only one is available).

Event(s) generated (unless masked away): When the command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[out]

p_return

Extra return parameters.

Return values

0	if success.

Returns

Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.