sdc_hci_cmd_le_cs_remove_config()

uint8_t sdc_hci_cmd_le_cs_remove_config

(

const sdc_hci_cmd_le_cs_remove_config_t *

p_params

)

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE CS Remove Config.

The description below is extracted from Core_v6.0, Vol 4, Part E, Section 7.8.138

The HCI_LE_CS_Remove_Config command is used to remove a CS configuration identified by Config_ID from the local Controller for the connection identified by the Connection_Handle parameter. When the Host issues this command, the local Controller shall initiate a Channel Sounding Configuration procedure to remove the CS configuration from both the local and remote device. The Controller shall delete any CS procedure related parameters set using the HCI_LE_CS_Set_Procedure_Parameters command for the CS configuration identified by Config_ID.

If the CS configuration corresponding to Config_ID does not exist, then the Controller shall return the error code Invalid HCI Command Parameters (0x12).

If the Host issues this command when one or more CS procedures have been enabled using the HCI_LE_CS_Procedure_Enable command, then the Controller shall return the error code Command Disallowed (0x0C).

If the Host sends this command with a Connection_Handle that does not exist, or the Connection_Handle is not for an ACL, then the Controller shall return the error code Unknown Connection Identifier (0x02).

Event(s) generated (unless masked away): When the Controller receives the HCI_LE_CS_Remove_Config command, the Controller shall send the HCI_Command_Status event to the Host. When the Controller has completed the Channel Sounding Configuration procedure to disable the configuration, the Controller shall generate an LE_CS_Config_Complete event.

Parameters

[in]

p_params

Input parameters.

Return values

0	if success.

Returns

Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.