sdc_hci_cmd_le_iso_receive_test()

uint8_t sdc_hci_cmd_le_iso_receive_test	(	const sdc_hci_cmd_le_iso_receive_test_t *	p_params,
		sdc_hci_cmd_le_iso_receive_test_return_t *	p_return )

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE ISO Receive Test.

The description below is extracted from Core_v6.0, Vol 4, Part E, Section 7.8.112

The HCI_LE_ISO_Receive_Test command should only be used in the ISO Test mode and only for testing purposes.

The command is used to configure an established CIS or a synchronized BIG specified by the Connection_Handle parameter to receive payloads.

When using this command for a BIS, the Host shall synchronize with a BIG using the HCI_LE_BIG_Create_Sync command before invoking this command.

The Payload_Type parameter defines the configuration of SDUs in the payload.

If the Host issues this command with a connection handle that is not for an established CIS or a BIS, the Controller shall return the error code Unknown Connection Identifier (0x02).

If the Host issues this command when the value of the receive BN parameter of the CIS or BIS is set to zero, the Controller shall return the error code Unsupported Feature or Parameter Value (0x11).

If the Host has set the output data path for the CIS or BIS identified by the Connection_Handle parameter, the Controller shall return the error code Command Disallowed (0x0C).

Event(s) generated (unless masked away): When the HCI_LE_ISO_Receive_Test command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[in]	p_params	Input parameters.
[out]	p_return	Extra return parameters.

Return values

0	if success.

Returns

Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.