sdc_hci_cmd_le_remove_iso_data_path()

uint8_t sdc_hci_cmd_le_remove_iso_data_path	(	const sdc_hci_cmd_le_remove_iso_data_path_t *	p_params,
		sdc_hci_cmd_le_remove_iso_data_path_return_t *	p_return )

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE Remove ISO Data Path.

The description below is extracted from Core_v6.0, Vol 4, Part E, Section 7.8.110

The HCI_LE_Remove_ISO_Data_Path command is used to remove the input and/or output data path(s) associated with a CIS, CIS configuration, or BIS identified by the Connection_Handle parameter.

The Data_Path_Direction parameter specifies which directions are to have the data path removed.

If the Host issues this command with a Connection_Handle that does not exist or is not for a CIS, CIS configuration, or BIS, the Controller shall return the error code Unknown Connection Identifier (0x02).

If the Host issues this command for a data path that has not been set up (using the HCI_LE_Setup_ISO_Data_Path command), the Controller shall return the error code Command Disallowed (0x0C).

Event(s) generated (unless masked away): When the HCI_LE_Remove_ISO_Data_Path command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[in]	p_params	Input parameters.
[out]	p_return	Extra return parameters.

Return values

0	if success.

Returns

Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.