sdc_hci_cmd_cb_read_authenticated_payload_timeout()

uint8_t sdc_hci_cmd_cb_read_authenticated_payload_timeout	(	const sdc_hci_cmd_cb_read_authenticated_payload_timeout_t *	p_params,
		sdc_hci_cmd_cb_read_authenticated_payload_timeout_return_t *	p_return )

#include <softdevice_controller/include/sdc_hci_cmd_controller_baseband.h>

Read Authenticated Payload Timeout.

The description below is extracted from Core_v6.0, Vol 4, Part E, Section 7.3.93

This command reads the Authenticated_Payload_Timeout (authenticatedPayloadTO, see [Vol 2] Part B, Appendix B for BR/EDR connections and [Vol 6] Part B, Section 5.4 for LE connections) parameter in the Controller on the specified Connection_Handle.

When the Connection_Handle identifies a BR/EDR synchronous connection or an LE BIS or CIS, the Controller shall return the error code Command Disallowed (0x0C).

Event(s) generated (unless masked away): When the HCI_Read_Authenticated_Payload_Timeout command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[in]	p_params	Input parameters.
[out]	p_return	Extra return parameters.

Return values

0	if success.

Returns

Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.