nxp,kinetis-ethernet

Vendor: NXP Semiconductors

Description

NXP Kinetis Ethernet

Properties

Top level properties

These property descriptions apply to “nxp,kinetis-ethernet” nodes themselves. This page also describes child node properties in the following sections.

Properties not inherited from the base binding file.

Name

Type

Details

local-mac-address

uint8-array

Specifies the MAC address that was assigned to the network device

zephyr,random-mac-address

boolean

Use a random MAC address generated when the driver is initialized.
Note that using this choice and rebooting a board may leave stale
MAC address in peers' ARP caches and lead to issues and delays in
communication.  (Use "ip neigh flush all" on Linux peers to clear
ARP cache.)

It is driver specific how the OUI octets are handled.

If set we ignore any setting of the local-mac-address property.

phy-handle

phandle

Specifies a reference to a node representing a PHY device.

phy-connection-type

string

Specifies the interface connection type between ethernet MAC and PHY.

Legal values: 'mii', 'rmii', 'gmii'

pinctrl-0

phandles

Pin configuration/s for the first state. Content is specific to the
selected pin controller driver implementation.

pinctrl-1

phandles

Pin configuration/s for the second state. See pinctrl-0.

pinctrl-2

phandles

Pin configuration/s for the third state. See pinctrl-0.

pinctrl-3

phandles

Pin configuration/s for the fourth state. See pinctrl-0.

pinctrl-4

phandles

Pin configuration/s for the fifth state. See pinctrl-0.

pinctrl-names

string-array

Names for the provided states. The number of names needs to match the
number of states.

phy-addr

int

Address of the phy controller

This property is required.

reset-gpios

phandle-array

GPIO to reset PHY. Reset signal is assumed active low.

int-gpios

phandle-array

interrupt GPIO for PHY. Will be pulled high before reset is asserted.

Child node properties

Name

Type

Details

speed

int

The speed of fixed link

This property is required.

Legal values: 100, 10

full-duplex

boolean

The fixed link operates in full duplex mode