nxp,nx20p3483 (on i2c bus)

Vendor: NXP Semiconductors

Description

NXP NX20P3483 Power path controller chip

Properties

Properties not inherited from the base binding file.

Name

Type

Details

supply-gpios

phandle-array

GPIO specifier that controls power to the device.

This property should be provided when the device has a dedicated
switch that controls power to the device.  The supply state is
entirely the responsibility of the device driver.

Contrast with vin-supply.

vin-supply

phandle

Reference to the regulator that controls power to the device.
The referenced devicetree node must have a regulator compatible.

This property should be provided when device power is supplied
by a shared regulator.  The supply state is dependent on the
request status of all devices fed by the regulator.

Contrast with supply-gpios.  If both properties are provided
then the regulator must be requested before the supply GPIOS is
set to an active state, and the supply GPIOS must be set to an
inactive state before releasing the regulator.

irq-gpios

phandle-array

Interrupt pin

snk-ovp

int

Sink high-voltage overvoltage protection threshold in millivolts. This value must be set using one of the NX20P348X_U_THRESHOLD_* defines.

Default value: 1

src-hv

boolean

If set, source role will use high-voltage path instead of 5V.

src-hv-ocp

int

Source high-voltage overcurrent protection threshold in milliamperes. This value must be set using one of the NX20P348X_I_THRESHOLD_* defines.

Default value: 6

src-5v-ocp

int

Source 5V overcurrent protection threshold in milliamperes. This value must be set using one of the NX20P348X_I_THRESHOLD_* defines.

Default value: 6