sensirion,shtcx (on i2c bus)

Vendor: Sensirion AG

Description

Sensirion SHTCx humidity and temperature sensor

Properties

Properties not inherited from the base binding file.

Name

Type

Details

friendly-name

string

Human readable string describing the sensor. It can be used to
distinguish multiple instances of the same model (e.g., lid accelerometer
vs. base accelerometer in a laptop) to a host operating system.

This property is defined in the Generic Sensor Property Usages of the HID
Usage Tables specification
(https://usb.org/sites/default/files/hut1_3_0.pdf, section 22.5).

supply-gpios

phandle-array

GPIO specifier that controls power to the device.

This property should be provided when the device has a dedicated
switch that controls power to the device.  The supply state is
entirely the responsibility of the device driver.

Contrast with vin-supply.

vin-supply

phandle

Reference to the regulator that controls power to the device.
The referenced devicetree node must have a regulator compatible.

This property should be provided when device power is supplied
by a shared regulator.  The supply state is dependent on the
request status of all devices fed by the regulator.

Contrast with supply-gpios.  If both properties are provided
then the regulator must be requested before the supply GPIOS is
set to an active state, and the supply GPIOS must be set to an
inactive state before releasing the regulator.

chip

string

Specifies which chip exactly is used. This is necessary to get exact
timing information and supported command set.
SHTC3 has an additional sleep mode that is entered between measurements.

This property is required.

Legal values: 'shtc1', 'shtc3'

measure-mode

string

Specifies which measurement mode is used.
SHTC1 sensor only supports the normal measuremnt mode.

This property is required.

Legal values: 'normal', 'low-power'

clock-stretching

boolean

Specifies that the driver should clock stretching i2c communication to
read the sensor values.